Register Description - NXP Semiconductors PN7462 series User Manual

NXP Semiconductors
Name
INTERNAL_USE
CLIF_ANA_TX_SHAPE_CONTROL
_REG
INTERNAL_USE
CLIF_ANA_TEST_REG
INTERNAL_USE
INTERNAL_USE
CLIF_DPLL_INIT_REG
INTERNAL_USE
INTERNAL_USE
INTERNAL_USE
INTERNAL_USE
CLIF_INT_CLR_ENABLE_REG
CLIF_INT_SET_ENABLE_REG
CLIF_INT_STATUS_REG
CLIF_INT_ENABLE_REG
CLIF_INT_CLR_STATUS_REG
CLIF_INT_SET_STATUS_REG

12.6 Register description

Table 186. CLIF_CONTROL_REG register (address 0000h)
* = reset value
Bit Symbol
31:4 RESERVED
3 START_SEND
2:0 COMMAND
UM10858
User manual
COMPANY PUBLIC
Address Width
offset (bits)
0124h 32
0128h 32
012Ch 32
01FCh 32
0200h 32
0204h 32
0208h 32
020Ch 32
0210h 32
0214h 32
0218h 32
3FD8h 32
3FDCh 32
3FE0h 32
3FE4h 32
3FE8h 32
3FECh 32
Access Value Description
R 0 Reserved
D 0*, 1 Set to logic 1, the data transmission is started.
Note: This bit is only valid in combination with the transceive command
Note: If TXWait is set to a value other than zero the TXWait period
configured must be expired as well that the transmission starts
As soon as the transmission started this bit is cleared by hardware.
D 0 - 5 These registers hold the command bits
0* IDLE/StopCom Command; stops all ongoing communication and set
the CLIF to IDLE mode; reset value
1 Transmit command; starts a transmission immediately
2 Receive command; enables the receiver. After end of reception the bits
are clear and IDLE
3 Transceive command; initiates a transceive cycle.
Note: Depending on the value of the Initiator bit a transmission is
started or the receiver is enabled
All information provided in this document is subject to legal disclaimers.
Rev. 1.4 — 14 May 2018
Access Reset value Description
R/W 00000000h
R/W 00000000h
R/W 00000000h
R/W 0050004Ah
R/W FF000000h
R/W 00000000h
R/W 00000000h
R/W 00000000h
R/W 00000000h
R/W 00000000h
R/W 00000000h
W 00000000h
W 00000000h
R 00000000h
R 00000000h
W 00000000h
W 00000000h
314514
UM10858
PN7462 family HW user manual
For internal use
Analog TX shaping control register
For internal use
Analog test control register
For internal use
For internal use
DPLL Configuration Register
For internal use
For internal use
For internal use
For internal use
Interrupt register
Interrupt register
Interrupt register
Interrupt register
Interrupt register
Interrupt register
© NXP B.V. 2018. All rights reserved.
155 of 345