NXP Semiconductors PN7462 series User Manual page 116

NXP Semiconductors
Bit Symbol
10
VBUSP_MON_HIGH_INT_
CLR_STATUS
9
CLIF_RFLD_ACT_INT_CLR
_STATUS
8
VBUS_MON_LOW_INT_CL
R_STATUS
7
VBUSP_MON_LOW_INT_C
LR_STATUS
6
PVDD_CURLIM_ACT_CLR
_STATUS
5
TEMPERROR1_INT_CLR_
STATUS
4
TEMPERROR0_INT_CLR_
STATUS
3
SUSPEND_DEFAULTED_I
NT_CLR_STATUS
2 RESERVED
1
SUSPEND_INT_CLR_STAT
US
0
GPIO_INT_CLR_STATUS
Table 135. PCR_INT_SET_STATUS_REG (address offset 0x3FEC)
Bit Symbol
31:28 RESERVED
27
GPIO12_PAD_HIGH_INT_S
ET_STATUS
26
GPIO11_PAD_HIGH_INT_S
ET_STATUS
25
GPIO10_PAD_HIGH_INT_S
ET_STATUS
24
GPIO9_PAD_HIGH_INT_S
ET_STATUS
UM10858
User manual
COMPANY PUBLIC
Access Value Description
VBUSP monitor going high interrupt clear status
1: Clear VBUSP monitor high interrupt. Auto clear after 2
-x 0x00 cycles.
Clif RF field activity observed interrupt clear status
1: Clear RF level detected interrupt. Auto clear after 2
-x 0x00 cycles.
VBUS monitor going low interrupt clear status
1: Clear VBUS monitor low interrupt. Auto clear after 2
-x 0x00 cycles.
VBUSP monitor going low interrupt clear status
1: Clear VBUSP monitor low interrupt. Auto clear after 2
-x 0x00 cycles.
PVDD current limiter active interrupt clear status
1: Clear PVDD current limiter interrupt. Auto clear after 2
-x 0x00 cycles.
Temperature error 1 interrupt clear status
1: Clear temperature sensor 1 error interrupt. Auto clear
-x 0x00 after 2 cycles.
Temperature error 0 interrupt clear status
1: Clear temperature sensor 0 error interrupt. Auto clear
-x 0x00 after 2 cycles.
Suspend defaulted interrupt clear status
1: Clear suspend prevented interrupt. Auto clear after 2
-x 0x00 cycles.
-x 0x00 Reserved
Suspend interrupt clear status.
1: Clear suspend (exit) interrupt. Auto clear after 2
-x 0x00 cycles.
GPIO interrupt clear clear status
-x 0x00 1: Clear GPIO interrupt. Auto clear after 2 cycles.
Access Value Description
-x 0x00 Reserved
GPIO12 pad going high interrupt set status
-x 0x00 1: Set GPIO12 interrupt. Auto clear after 2 cycles.
GPIO11 pad going high interrupt set status
-x 0x00 1: Set GPIO11 interrupt. Auto clear after 2 cycles.
GPIO10 pad going high interrupt set status
-x 0x00 1: Set GPIO10 interrupt. Auto clear after 2 cycles.
GPIO9 pad going high interrupt set status
-x 0x00 1: Set GPIO9 interrupt. Auto clear after 2 cycles.
All information provided in this document is subject to legal disclaimers.
Rev. 1.4 — 14 May 2018
314514
UM10858
PN7462 family HW user manual
© NXP B.V. 2018. All rights reserved.
116 of 345