NXP Semiconductors PN7462 series User Manual page 112

NXP Semiconductors
Bit Symbol
17
GPIO2_PAD_HIGH_INT_S
ET_ENABLE
16
GPIO1_PAD_HIGH_INT_S
ET_ENABLE
15:11 RESERVED
10
VBUSP_MON_HIGH_INT_S
ET_ENABLE
9
CLIF_RFLD_ACT_INT_SET
_ENABLE
8
VBUS_MON_LOW_INT_SE
T_ENABLE
7
VBUSP_MON_LOW_INT_S
ET_ENABLE
6
PVDD_CURLIM_ACT_SET
_ENABLE
5
TEMPERROR1_INT_SET_
ENABLE
4
TEMPERROR0_INT_SET_
ENABLE
3 SUSPEND_
DEFAULTED_INT_SET_EN
ABLE
2 RESERVED
1
SUSPEND_INT_SET_ENA
BLE
0
GPIO_INT_SET_ENABLE
Table 132. PCR_INT_STATUS_REG (address offset 0x3FE0)
Bit Symbol
31:28 RESERVED
27
GPIO12_PAD_HIGH_INT_S
TATUS
26
GPIO11_PAD_HIGH_INT_S
TATUS
25
GPIO10_PAD_HIGH_INT_S
TATUS
24
GPIO9_PAD_HIGH_INT_ST
ATUS
UM10858
User manual
COMPANY PUBLIC
Access Value Description
GPIO2 pad going high interrupt set enable
-x 0x00 1: Enable GPIO2 interrupt
GPIO1 pad going high interrupt set enable
-x 0x00 1: Enable GPIO1 interrupt
-x 0x00 Reserved
VBUSP monitor going high interrupt set enable
-x 0x00 1: Enable VBUSP Monitor high interrupt
Clif RF field activity observed interrupt set enable
-x 0x00 1: Enable RF level detected interrupt
VBUS monitor going low interrupt set enable
-x 0x00 1 – Enable VBUS monitor low interrupt
VBUSP monitor going low interrupt set enable
-x 0x00 1 – Enable VBUSP monitor low interrupt
PVDD current limiter active interrupt set enable.
-x 0x00 1 – Enable PVDD current limiter interrupt
Temperature error 1 interrupt set enable
-x 0x00 1 – Enable temperature sensor 1 error interrupt
Temperature error 0 interrupt set enable
-x 0x00 1 – Enable temperature sensor 0 error interrupt
Suspend defaulted interrupt set enable
-x 0x00 1: Enable suspend prevented interrupt
rw 0x00 Reserved
suspend interrupt set enable.
-x 0x00 1: Enable suspend(exit) interrupt
GPIO interrupt clear enable
-x 0x00 1: Enable GPIO interrupt
Access Value Description
rw 0x00 Reserved
GPIO12 pad going high interrupt status
r- 0x00 1: Indicates GPIO12 interrupt is set.
GPIO11 pad going high interrupt status
r- 0x00 1: Indicates GPIO11 interrupt is set.
GPIO10 pad going high interrupt status
r- 0x00 1: Indicates GPIO10 interrupt is set.
GPIO9 pad going high interrupt status
r- 0x00 1: Indicates GPIO9 interrupt is set.
All information provided in this document is subject to legal disclaimers.
Rev. 1.4 — 14 May 2018
314514
UM10858
PN7462 family HW user manual
© NXP B.V. 2018. All rights reserved.
112 of 345