Send - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
7.6.1.0
7.5.1.0
E-Series
Usage Information If there is a change in the configuration, the system prompts you to save the new
configuration. Or you can save your running configuration with the copy running-
config command. Use the conditional parameter if any configuration changes made
to the nvram, such as stack-group and fanout configurations, must be saved.
To halt a port extender (PE) or an entire PE stack, and perform a cold-restart (from a PE
console), use the reload command.

send

Send messages to one or all terminal line users.
C9000 Series
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
*
line
console
vty
Defaults none
Description
Introduced on the C9010 and C1048P.
Introduced on the Z9500.
Added 'conditional' parameter.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Enter the asterisk character * to send a message to all tty lines.
Send a message to a specific line. The range is from 0 to 11.
Enter the keyword console to send a message to the primary
terminal line.
Enter the keyword vty to send a message to the virtual terminal.
Control and Monitoring 114