Ike Policy Attributes Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
IKE P A
OLICY
To activate the IKE Policy Attributes mode, enter the attribute command at the IKE Policy prompt. For
example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#crypto ike policy 1
ProCurve(config-ike)#attribute 10
ProCurve(config-ike-attribute)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
authentication [dss-sig | pre-share | rsa-sig]
encryption [aes-xxx-cbc | des | 3des]
group [1 | 2 | 5] on page 1257
hash [md5| sha] on page 1258
lifetime <seconds>
Note
For VPN configuration example scripts, refer to the VPN Configuration Guide located on
the ProCurve SROS Documentation CD provided with your unit.
5991-2114
C
TTRIBUTES OMMAND
on page 1256
on page 1259
© Copyright 2007 Hewlett-Packard Development Company, L.P.

IKE Policy Attributes Command Set

S
ET
on page 1255
1254