HP ProCurve 7102dl Reference Manual page 1263

SROS Command Line Interface Reference Guide
attribute <policynumber>
Use the attribute command to define attributes for the associated IKE policy. Multiple attributes can be
created for a single IKE policy. Once you enter this command, you are in the IKE Policy Attribute. Refer
to IKE Policy Attributes Command Set on page 1254 for more information.
Syntax Description
<policynumber>
Default Values
By default, no attribute is defined.
Functional Notes
Multiple attributes on an IKE policy are ordered by number (with the lowest number representing the highest
priority).
Usage Examples
The following example defines a policy attribute (10) and takes you into the IKE Policy Attributes:
ProCurve(config-ike)#attribute 10
ProCurve(config-ike)#
5991-2114
Assigns a number (range: 1 to 65,535) to the attribute policy. The number is the
attribute's priority number and specifies the order in which the resulting VPN
proposals get sent to the far end.
This command takes you to the (config-ike-attribute)# prompt. From here, you
can configure the settings for the attribute as outlined in the section
Attributes Command Set
© Copyright 2007 Hewlett-Packard Development Company, L.P.
on page 1254.
IKE Policy Command Set
IKE Policy
1261