Route Map Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
R M C
OUTE AP
To activate the Route Map Interface Configuration mode, enter the route-map command at the Global
Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#route-map MyMap permit 100
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
match as-path <name>
match community <name> [exact-match]
match ip address <access list name>
match ip address prefix-list <prefix-list name>
match ip dscp [<value> | afxx | csxx | default | ef]
match ip precedence [<value> | critical | flash | flash-override | immediate | internet | network |
priority | routine]
match metric <value>
match tag <value>
set as-path prepend [<number> | last-as <number>]
set comm-list <name> delete
set community [<community-number> | internet | local-as | no-export | no-advertise | none] [add]
on page 1290
set default interface [<interface> | null 0]
set interface <interface type> <interface id>
set ip default next-hop [<interface> | null 0]
set ip df on page 1294
set ip dscp [<value> | afxx | csxx | default | ef]
set ip next-hop <address>
set ip precedence [<value> | critical | flash | flash-override | immediate | internet | network | priority
| routine] on page 1297
5991-2114
S
OMMAND ET
on page 1434
on page 1276
on page 1278
on page 1283
on page 1286
on page 1287
on page 1289
on page 1296
© Copyright 2007 Hewlett-Packard Development Company, L.P.
on page 1277
on page 1279
on page 1280
on page 1288
on page 1291
on page 1292
on page 1293
on page 1295

Route Map Command Set

on page 1431
1274