Oil Filter - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

2. Install two guide pins, 1, into the face of the

engine block.

3. Insert the port block assembly into installer

FNH00117 and place on the guide pins. Drive the

port block into the engine block until the installer

bottoms against the face of the engine block.

NOTE: Drive only against the installation tool. Do not

strike the oil pump shaft.

Use of the installer tool assures correct

alignment of the oil passages in the engine block

with those in the port block.

Op. 10 304 10

OIL FILTER

Construction and Function

This engine employs a cartridge-type filter.

Pressurized oil from the pump enters from 1 and is

filtered by a full flow filter before discharge through 2.

When the full flow filter is clogged, the safety valve,

3, opens to bypass the oil.

The oil filter must be replaced every 100 hours of

When installing a new filter, coat its mounting face

with clean oil. Hand-tighten only.

SECTION 10 - ENGINE

Table of Contents