New Holland LS140 Workshop Manual page 84

Bearing Size
Standard
Crankshaft Journal Diameter
67.957 - 67.720 mm
(2.6755" - 2.6760")
0.25 mm (0.010")
Crankshaft Journal Diameter
67.707 - 67.770 mm
(2.6656" - 2.6661")
0.50 mm (0.020")
Crankshaft Journal Diameter
67.457 - 67.470 mm
(2.6558" - 2.6563")
Thrust Washers
Inspect the thrust washers for wear, poor contact,
burning, or other defects. Defective thrust washers
must be replaced.
Standard Thickness
2.95 - 3.0 mm
(0.116" - 0.118")
REASSEMBLY
Reassemble the bearings, bearing holders, and
thrust washer as follows:
1. Install the bearing liner with the oil groove, 1, in
the upper half of the bearing holder. Liners
without the oil groove go in the lower bearing
holders.
2. Install the thrust washers, 2, in the lower half of
the rear bearing holder. Face the oil grooves to
the crankshaft surface.
3. Position the chamfered edge, 3, of each bearing
holder facing forward. Install the bearing holder
with the notch, 4, in the center position.
4. Torque the bearing holder bolts to 49 - 54 N⋅m (36
- 40 ft. lbs.).
SECTION 10 - ENGINE
Allowable Limit
2.8 mm
(0.10" )
10-49
PH050
Copyright © New Holland
71