New Holland LS140 Workshop Manual page 380

Hide thumbs Also See for LS140:

Table of Contents

23. Removing the slack from the wire harness along

the top of ROPS at 1, and along the top of the final

drive case at 2, pull the slack to the front and re-

taining loop at 3. Secure the wire harness with

clamps and ties previously removed.

24. Reinstall the seat/seat pan support assembly re-

taining hardware, 1, and connect the seat/seat

belt wire harness to the main wire harness. Make

sure the wire harness is to the inside of the boom

lock linkage to prevent interference when the

seat pan support assembly is pivoted up to the

raised, latched position. Reattach the latch rod,

2, and install the retaining pin.

25. Reinstall the headliner and supports.

26. Reinstall the rear window glass and molding, 1,

if removed, and reinstall the locking strip to se-

cure the glass in the molding.

SECTION 39 - FRAMES

Chapters

Table of Contents