New Holland LS140 Workshop Manual page 611

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

3. Loosen the front link pivot hardware, 1, and with

a soft-faced sledge hammer, strike the link at 2,

to loosen the tapered pin in the ROPS post.

4. Remove the front and rear pivot pin retaining

bolts and tapered pins and lift the link from the

Op. 82 100 50

Main Boom Removal

1. The boom lower link, 1, and boom cylinder pivot

pin, 2, hardware is accessed from inside the op-

erator's area.

2. Remove the fenders to gain access to the boom

and bucket hydraulic tube and hose connections.

3. With the boom properly supported and all hy-

draulic oil pressure removed from the boom,

bucket, and auxiliary hydraulic circuits, discon-

nect the hydraulic lines at 1. Cap open ends of

lines and hoses. Remove the boom hose clamps,

2, retaining the hoses to the lower boom links.

Remove the hoses from the lower hose retainer,

Always use a suitable lifting device and chains or

straps to support and remove the boom.

Do not disconnect any hydraulic lines until all hy-

draulic pressure is removed from the boom and

bucket hydraulic circuits.

Chapters

Table of Contents