New Holland LS140 Workshop Manual page 409

Hide thumbs Also See for LS140:

Table of Contents

11. Reinstall the intermediate shaft assembly, 1, into

the hub at 2.

12. Install the wear ring, 3. If the ring is worn or dam-

aged, replace.

13. Install the inner bearing, 1, onto the intermediate

shaft, by using the large flat washer, 2, and a 1/2"

x 2" HHCS at 3, to press the bearing onto the

shaft. After the bearing has started squarely onto

the shaft, replace the 2" bolt with the original 1/2"

x 1-1/2" HHCS, pull the bearing into place and

torque the bolt to 88 N·m (65 ft. lbs.).

NOTE: NOTE: The intermediate shaft bearing as-

sembly is not shimmed. Torquing the retaining bolt

will set the bearings to the correct position and di-

14. Place a bead of noncorrosive silicone sealer

around the cover plate at 1, and tap into place.

NOTE: NOTE: Lubricate the shaft and bearing as-

sembly with New Holland high viscosity lithium

grease at 2, rotating the shaft to ensure the cavity is

filled with grease.

SECTION 44 - AXLES AND WHEELS

Chapters

Table of Contents