New Holland LS140 Workshop Manual page 375

Hide thumbs Also See for LS140:

Table of Contents

29. With the boom properly supported, remove the

rear ROPS attaching hardware, 1, right and left

30. Remove the front ROPS attaching hardware, 1,

right and left sides. Remove the ground strap, 2,

from the ROPS post at 3.

Lift the cab/ROPS/boom assembly from the low-

er main frame.

Place the assembly on the floor and lower the

boom to the lowered position.

REINSTALLATION

1. Lift the ROPS/boom assembly back into position

using caution not to set the ROPS on any hydrau-

lic lines or electrical wires.

2. Position the front ROPS post into the front brack-

ets, 1, and install the front support hardware, 2,

(two each side). Do not tighten.

SECTION 39 - FRAMES

Chapters

Table of Contents