New Holland LS140 Workshop Manual page 618

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

12. Route the tubes and hoses to the rear of the

boom through the rear hose supports, 1, and on

the top side of the lower link at 2, as shown.

13. Position the hoses with one on each side of the

lower link retaining clips, 1, and through the hose

retainer at 2. Do not tighten clamps at this time;

further adjustment will be required later.

14. Attach the hoses to the hose support at 3, as

15. Reconnect the hoses to the tubes at 4, position-

ing the hoses and tubes for clearance to the fend-

er when the boom is raised and lowered.

16. When all boom links and pivot pins are properly

seated and torqued and all hydraulic connec-

tions are tightened, operate the boom, 1, up and

down. Check the clearance between the tube

and ROPS (cab) at 2.

Chapters

Table of Contents