New Holland LS140 Workshop Manual page 187

Hide thumbs Also See for LS140:

Table of Contents

9. Install shaft and bearing assembly, 1, into the

housing. Install the washer, 2, and new shaft

seal, 3; secure with retaining ring, 4.

NOTE: The washer should be installed before the

shaft seal. It should not be installed between the seal

and outer retaining ring.

10. Check the three piston block loading pins, 1.

Make sure they are seated properly in the over-

size grooves in the splines and held in place with

the retaining ring, 2.

Reinstall the piston plate assembly, 1, and pivot,

2, into the block with the pivot resting on the load-

ing pins, 3.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents