New Holland LS140 Workshop Manual page 378

12. Route the wire harness up through the slot in the
left rear of the cab at 1, and along the rear of cab
at 2.
13. Route the wire harness up the inside of the right
rear cab post, 3, and to the front of the cab to the
service/run switch and ignition switch areas.
14. Route the wire harness to the front of the cab to
the EIC board area. Place the ignition switch pan-
el, 1, into the dash, positioning the harness to
prevent damage to the harness and to avoid con-
tacting any sharp surfaces.
Reinstall any wire clamps and ties removed in the
front of the cab dash area.
15. Reattach the wire harness to the EIC board, mak-
ing sure the connectors are securely locked into
position and not contacting the back of the EIC
board.
16. Reattach the wire harness connectors, 1, to the
front road/work lights and reinstall the light bez-
els.
SECTION 39 - FRAMES
39-13
Copyright © New Holland
3
32
33
34