New Holland LS140 Workshop Manual page 230

Hide thumbs Also See for LS140:

Table of Contents

1. Take note of the number and position of all shim

washers for reassembly.

2. Remove the bolt, 1, securing the ball end to the

control arm.

3. Remove the jam nut, 2, and ball end, 3, from the

4. Remove the groove pin, 5, from the arm, 6.

5. Loosen the set screw, 7, on the set collar. Re-

move the cotter pins, 8, and shim washers, 9, tak-

ing note of the number of shim washers for reas-

6. Remove the bearings, 10, from the control han-

dle and the bearings, 11, from the handle mount-

ing plates. Slide the handle sideways and re-

move from the stub shafts.

7. Remove the nuts, 1, lock washers, and carriage

bolts securing the handle support to the handle

tube. Remove the handle support, 2, and control

rod, 3, from the handle tube, 4.

8. Remove the locknut, 1, and bolt to separate the

handle from the handle support.

9. Remove the ball end, 2, from the handle by re-

moving the capscrew, 3, flat washer and locknut.

Remove the ball end, 2, and jam nut, 4, from the

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents