Reattaching Cylinders After Repair With Boom Resting On Boom Lock Pins - New Holland LS140 Workshop Manual

6. With an Operator sitting in the Operator's seat
with the seat belt buckled.
7. Slowly raise the boom above the boom lock pins,
1.
8. Operator sitting in seat, engage the boom lock
pins, 1.
9. Lower the boom and rest on the boom lock pins, 1.
CAUTION
The operator must not leave the operator's seat
until the boom is resting solidly on the boom lock
pins. The boom could drop suddenly if lifting
devices should fail.
REATTACHING CYLINDERS AFTER
REPAIR WITH BOOM RESTING ON BOOM
LOCK PINS
1. Support the rod end of cylinders, 1, off the boom
upper links, 2, to align with main boom cylinder
pivot pin holes, 3.
2. Operator sitting in the Operator's seat with seat
belt buckled.
3. Start the engine and hydraulically extend
cylinder rods to align cylinder with pivot pin, 1.
Stop engine.
4. Turn the ignition key to the "ON" position. Foot
controls, press the toe of the left foot pedal, boom
control, or hand controls, pivot the left hand
control lever down, into the boom float position,
turn the ignition key to the "OFF" position.
5. If cylinder and boom are not properly aligned,
use a pry bar to align cylinder and boom.
6. Install pivot pin, 1, and secure with retaining
hardware, 2. Torque bolts to 38 N
7. Start the engine and hydraulically extend the
second cylinder rod to align cylinder with pivot
pin. Stop engine.
8. If cylinder and boom are not properly aligned, sit
in the operator's seat with seat buckled, turn the
ignition key to the "ON" position.
SECTION 00 - GENERAL INFORMATION
10995770
10995771
10995772
⋅
m (28 ft. lbs.)
00-17
1
3
1
1
2
Copyright © New Holland
13
2
14
15