New Holland LS140 Workshop Manual page 343

Hide thumbs Also See for LS140:

Table of Contents

PARTS INSPECTION

1. Thoroughly clean all parts and remove all nicks

and burrs with a fine emery cloth.

2. Inspect the inner diameter of the barrel for exces-

sive wear or scoring.

3. Inspect the gland thread area, 1, for damaged

threads that would prevent proper tightening of

4. Inspect the O ring seal area, 2, and remove burrs

or nicks that would prevent the O ring from seal-

ing properly.

5. Inspect the outer diameter of the piston for ex-

cessive wear or scoring. If the piston is damaged,

the inner surface of the barrel will likely be dam-

1. Clean and dry all parts. The metal parts should

be lightly oiled prior to assembly.

2. Install a new shaft seal, 1.

3. Install a wiper seal, 2.

NOTE: Install shaft wiper seal, 1, with the lip of the

seal facing the piston.

4. Install O ring, 1, and backup washer, 2, on the cyl-

inder gland.

SECTION 35 - HYDRAULIC SYSTEM

Chapters

Table of Contents