SECTION 90 - PLATFORMS, CAB, BODYWORK, AND DECALS
5. To adjust the latches, 1, lower the seat down to
the operating position and slide the latches, 1, to
obtain full engagement of latches and latch rod.
After the latches are adjusted, release the latch
rod, raise seat and lower seat to the operating
position. Try lifting on the front of the seat to verify
the seat pan support is latched securely.
6. Reconnect the seat/seat belt wire harness
connector, 1, to the main wire harness behind the
seat.
NOTE: Position the seat/seat belt and main wire
harness to the front of the boom lock linkage to
prevent interference. If the wires are to the back side
of the linkage, the wires will not stay connected when
the seat is raised.
90-7
Copyright © New Holland
14
15