New Holland LS140 Workshop Manual page 464

1
EIC Diagnostics and Setup Items
Diagnostics Mode
With display showing "LOC_ _" for lock.
1. Press and release the "ARROW" switch, 1;
"dIAg" will appear in the character display, 2.
_______________________________________________________________________________________________
1
2. Press and hold the "OPEN BOOK" switch, 1, until
a low case "d" appears in the character display,
2, release the "OPEN BOOK" switch. The EIC is
now in Diagnostics.
Each individual monitored circuit can now be tested
for proper operation.
When in Diagnostics and any circuit is activated the
EIC board will light all lights and an audible alarm will
sound.
The Diagnostic test will not verify the performance of
a sensor or sender. Only the EIC board and wires to
the sender or sensor are tested.
The following circuits can be tested:
SECTION 55 - ELECTRICAL SYSTEM
2
2
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Transmission/hydraulic oil temperature circuit
11. Fuel level circuit
12. Seat switch(es) and circuit
13. Seat belt switch and circuit
14. Service/Run switch
55-39
EIC board bulbs
EIC board circuits
EIC board arrow and open book switches
Audible beeper
Engine air filter circuit
Hydraulic oil filter circuit
Hydrostatic transmission charge pressure circuit
Engine oil pressure circuit
Engine Coolant temperature circuit
Copyright © New Holland
26
27