New Holland LS140 Workshop Manual page 546

Op. 55 404 10
Rear Work and Taillight
1. Remove the center work light, 1, by pushing the
lens assembly to the left and lift the right side of
the assembly from the support.
2. Remove the red taillight lamps, 2, by unscrewing
the bezel self-tapping screws, and removing the
bezels, 3.
3. Unplug the wire harness from the bulb,
unlatching the connector, and sliding the harness
from the bulb.
4. Facing the back of the assembly, rotate the bulb
holder, 1, counterclockwise and remove the bulb
from the support. Replace the bulb.
5. For the clear rear work lamp, position the bulb so
when it is locked in position the connector, 2, is
pointed down with the clip, 3, to the right.
IMPORTANT: DO NOT touch the bulb during
removal and installation. The bulb may become
damaged or a premature failure may occur.
SECTION 55 - ELECTRICAL SYSTEM
55-121
3
2
Copyright © New Holland
3
176
3
177