New Holland LS140 Workshop Manual page 204

Hide thumbs Also See for LS140:

Table of Contents

1. Use a suitable solvent to thoroughly clean all

parts. Lay the parts on a clean cardboard and air

IMPORTANT: Due to tight tolerances and finish of

motor internal surfaces, it is very important to main-

tain absolute cleanliness during reassembly.

2. Use a clean SAE 10W-30 oil to lubricate all mov-

ing parts as they are being reassembled.

3. Install the new O ring, seal and retaining rings in-

cluded with the repair kit.

4. Motor Housing

If required, install a new needle bearing, 1, in the

motor housing with the numbered end toward the

outside (flange end) of the housing.

Install the bearing with the numbered end, 1, fac-

ing out towards the mounting flange end of the

motor housing, 2. Press into place and to the di-

mension shown, 1.78 mm (0.07").

NOTE: When installing bearings in the housing or

backplate, be careful not to damage the outer bear-

ing race. If the outer race is damaged, early bearing

and shaft failures could occur.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents