New Holland LS140 Workshop Manual page 240

10. Bucket control - Attach the handle and rod as-
sembly, 1, to the control handle by first sliding the
rod down through the control handle tube, 2.
11. Bucket control - Attach the handle assembly to
the handle tube arms, 3, with the short carriage
bolts, 4, lock washers, 5, and nuts, 6. Tighten se-
curely.
12. Boom hydraulics control - Install a new hand grip
on the top of the handle, 1, if grip is worn.
13. Boom hydraulics control - Attach the ball end, 2,
and jam nut, 3, to the rod, 4, and fasten to the
handle, 5, with a 5/16" x 1-1/4" capscrew, 6, flat
washer and locknut. Position the flat washer be-
tween the ball end and handle. Do not tighten the
jam nut at this time.
14. Boom hydraulics control - Attach the handle as-
sembly to the handle support, 8, with the long
bushing, 3/8" x 3-1/4" capscrew and locknut at 9.
15. Boom hydraulics control - Tighten the locknut to
remove any movement between the handle as-
sembly and support, but should be loose enough
to all the handle to pivot without binding.
16. Boom hydraulics control - Slide the handle tube
up through the slot, 1, in the handle support base.
17. Boom hydraulics control - Slide the handle side-
ways over the stub shafts.
18. Boom hydraulics control - Install the bearings, 2,
on the handle, install shim washers, 3, to center
the handle in the slot, 1. Fasten each bearing with
two 5/16" x 3/4" carriage bolts, lock washers, and
nuts, 4.
19. Boom hydraulics control - Install shim washers,
5, to reduce side play on the stub shafts. Retain
the shims on the stubs shaft with a roll pin, 6.
20. Boom hydraulics control - Slide the rubber boot,
7, down over the end of the control handle and
secure with the the hardware removed during
disassembly.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-95
5
6
1
2
19996838
1
5
9
2
19996889
7
4
2
5
6
4
3
Copyright © New Holland
3
4
211
6
8
3
7
4
212
1
4
213