New Holland LS140 Workshop Manual page 502

INSTALLATION
1. Connect the wire harness connectors P1 to J1
and P2 to J2 on the EIC board, making sure the
connectors are properly aligned and fully seated.
IMPORTANT: If the connector is not connected
correctly, damage to the EIC may occur:
•
Board circuits may burn out.
•
Display may not light up.
•
Board memory may be lost.
2. Position the EIC board into the overhead dash
flat against the support at 1, and secure with the
hardware previously removed at 2. Make sure
that wires are not pinched between the EIC board
and dash frame.
IMPORTANT: Do not force the EIC board into the
overhead dash area or damage to the EIC board may
occur.
3. Reconnect the negative (–) battery cable.
SECTION 55 - ELECTRICAL SYSTEM
55-77
Copyright © New Holland
83
84