New Holland LS140 Workshop Manual page 86

Hide thumbs Also See for LS140:

Table of Contents

Crankshaft Bushing Replacement

Bushing Removal

Remove the bushing from the cylinder block using a

bushing driver to prevent damage.

Bushing Installation

1. Prior to installing the bushing, inspect the

housing bore for burrs, scratches, etc.

2. The bushing should be pressed into the housing

to the correct depth using the following

a. Lubricate the outer surface of the bushing.

b. Align the oil hole, 1, in the bushing and

c. Press the bushing into the block from the

front side. This surface is chamfered to

accept the bushing.

NOTE: Do not install the bushing into the engine

block from the opposite side.

d. Press the bushing into the housing to correct

depth using a bushing driving tool.

3. After installation, confirm the correct alignment of

the oil hole in the bushing with the hole in the

SECTION 10 - ENGINE

Chapters

Table of Contents