Crankshaft Pulley; Injection Pump Installation - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

CRANKSHAFT PULLEY

Align the keyway and key on the crankshaft pulley

and crankshaft and assemble them.

Crankshaft pulley tightening torque:

275 - 333 N⋅m (203 - 246 ft. lbs.)

Installation generally follows the removal procedure

in reverse. If the pump or any pump drive component

(engine block, camshaft gear, camshaft, idler gear or

crankshaft) is replaced, it will be necessary to re-time

the pump. See Spill Timing Procedure.

Installation Using Original Pump and Drive

NOTE: The engine stop solenoid must be removed

before installing the pump.

1. Position the injection pump in the block using the

original shim gasket, 1, or a new one of the same

Connect the governor link to the pump control

rack and secure with the spring clip, 2.

NOTE: Check the control rack for any binding

condition by moving the pump control rack back and

2. Install the pump mounting bolts and tighten to

9-12 N⋅m (7 - 9 ft. lbs.).

If necessary to verify pump timing, spill time the

pump as outlined in Spill Timing Procedure.

SECTION 10 - ENGINE

Table of Contents