Engine Removal - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

Op. 10 001 10

ENGINE REMOVAL

The engine can be removed from the skid steer by

two methods:

Method 1 Removing the rear door, radiator, oil

cooler, and support as an assembly.

Method 2 Tilting the cab and boom forward to gain

Method 1 is the recommended procedure and should

be followed unless other circumstances require the

cab to be tilted.

For either method, raise and support the boom on the

boom lock pins, 1, to access the engine area.

(Without Tilting Cab)

1. Open rear door, 1. Remove the top engine hood,

2, and both the right and left engine side covers.

2. Remove the battery.

3. Drain the cooling system, radiator, and engine

4. Remove the upper and lower radiator hoses from

the engine block and plug the hoses with plastic

5. Remove the air cleaner hose, 1, from the intake

manifold and cap.

6. Unplug the engine wire harness from the main

harness, 2, and ground wires from the engine

bellhousing, 3.

7. Unhook the control valve hydraulic oil return line

at the oil cooler and cap at 4.

SECTION 10 - ENGINE

Table of Contents