New Holland LS140 Workshop Manual page 535

Hide thumbs Also See for LS140:

Table of Contents

6. Remove the right side plate, 1, and headliner, 2,

if equipped. Unhook all wire connections at the

service/run switch, preheat button, and fuse

block(s) at this time.

7. Remove the EIC board retaining hardware, 1,

unplug the EIC board and remove from the dash.

Remove the ignition key switch panel, 2, and

remove wires from the switches. Remove the

8. When unplugging the wire harness connectors,

1, from the EIC board, take care not to stress or

bend the plastic locking ramps on the

IMPORTANT: Note the positioning of the connectors

to the EIC board and reconnect in the same position.

If the connector is NOT connected properly, damage

to the EIC may occur.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents