New Holland LS140 Workshop Manual page 261

Hide thumbs Also See for LS140:

Table of Contents

Op. 33 110 48

Brake Caliper and Disc Removal

The skid steer must be properly supported with all

four wheels off the ground.

1. Remove the rear axle assembly and slide to the

front to loosen the drive chain.

2. Remove the rear drive chain from the drive

sprocket and push chain to the rear.

3. Remove the brake disc retaining ring, 1.

4. Loosen the caliper retaining hardware, 2, from in-

side the cab. Thread the two bolts from the out-

side caliper assembly, 3. DO NOT remove bolts

from caliper support at this time.

5. Remove the outside brake disc, 4.

6. Remove the brake caliper center section, 1, and

spacers, 2. Remove the retaining bolts.

7. Remove inside brake disc, 3.

8. Remove the brake friction puck, 1, and spacer

NOTE: NOTE: The spacer plate is thinner than the

friction puck and must be inserted into brake caliper

first upon reassembly.

SECTION 33 - BRAKES AND CONTROLS

Chapters

Table of Contents