5. Reassemble the motor drive shaft, 1, by installing
a new retaining ring, 2; thrust washer, 3; thrust
bearing, 4; and second thrust washer, 5. Secure
with a second new retaining ring, 6.
6. Install the shaft and bearing assembly, 1, into the
motor housing. Install the washer and new shaft
seal, 2, into the housing and set in place with a
seal driver. Secure the shaft in place with a new
retaining ring, 3.
7. Install the camplate, 1, into the motor housing, 2,
in the direction indicated on the camplate.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-60
Copyright © New Holland
120
121
122