New Holland LS140 Workshop Manual page 154

Hide thumbs Also See for LS140:

Table of Contents

Before performing any hydraulic test, operate the

skid-steer loader to get the hydraulic oil to operating

temperature (about 38° C [100° F] above ambient

temperature).

For access to hydrostatic testing, remove any attach-

ment from the loader attaching face plate and sup-

port the boom on the lockpins.

1. Raise the boom, extend the boom lockpins, 1,

and lower the boom down on the lockpins.

2. Stop the engine, turn the ignition key to the run

position, and operate the boom and bucket con-

trol pedals to relieve pressure in the cylinders.

Turn off the key.

3. Raise and support the skid-steer loader with all

four wheels off the ground. Support the front of

the loader at 1 to the front of the final drive case

and at 2 to the rear of the case.

Failure to securely support the skid-steer loader

could result in movement of the loader during

testing causing serious injury or damage to the

4. Put the "SERVICE/RUN" switch, 1, in the "SER-

VICE" position.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents