New Holland LS140 Workshop Manual page 377

7. Reattach the parking brake control link springs at
1, to the control rods, 2, and install the retaining
cotter pins at 3.
8. Route the throttle cable up through the cab frame
at 1, and secure the cable housing to the frame
with retaining nut, 2.
9. Reinstall yoke to cable and attach the cable to the
control lever at 3.
IMPORTANT: IMPORTANT: Route the throttle cable
from the engine to the control so there are no sharp
loops or contact with any moving linkage, park brake
or hydrostatic control linkages, etc.
10. Route the main wire harness along the left top of
final drive case and ROPS frame at 1, starting at
the left rear cab post at 2.
11. Pull about a 150 mm (6") loop of wire harness
through the retaining loop at the front of ROPS at
3. Do not clamp or tie the wire harness at this
time.
SECTION 39 - FRAMES
2
19992572
39-12
Copyright © New Holland
3
1
1
3
2
29
30
31