New Holland LS140 Workshop Manual page 606

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
9. Remove the control rod, 2, from the lever, 5, by
removing push nuts, 3. Slide the handle from the
rear of the cab.
10. Slide the boom pins, 1, right and left, from the
loader ROPS post.
11. The boom lock pins and linkage include:
1 Boom lock pins (2)
2 Control rod (1)
3 Push nuts (2)
4 Support angle (1)
5 Control lever assembly (1)
6 Plastic handle grip (1)
7 Spring (1)
REINSTALLATION
1. Install the boom lock pins, 1, right and left, into
the ROPS posts at 2.
2. Install a rubber grommet at 3. Insert the control
handle assembly, 4, through the right cab side
shield at 3.
3. Position the control handle over the lock pin, 1,
and install the support hardware at 5.
4. Install the handle and lock pin through bolt at 6.
5. With the handle properly positioned tighten the
support hardware at 5, and the through bolt lock-
nut, 6.
NOTE: Do not over-tighten the through bolt because
the handle must pivot at the lock pin.
82-17
Copyright © New Holland
1
33
34