New Holland LS140 Workshop Manual page 664

SECTION 90 - PLATFORMS, CAB, BODYWORK, AND DECALS
8. Remove the seat retaining hardware, 1, to
separate the seat and seat track from seat pan
support. Remove the wire clamp at 2, if the
seat/seat belt wire harness is being replaced.
9. Holding the seat in place, unplug the seat
switch(es). Disconnect the wire harness from the
switch(es) by releasing the latch away from the
switch.
10. To remove the seat tracks from the seat
assembly, remove the track retaining hardware,
1.
Op. 55 201 15
11. Remove the switch(es) from the seat pan, 2.
Note the standard seat, 3, uses one switch and
the deluxe seat, 4, uses two switches as shown.
12. To remove the seat/seat belt wire harness
remove the grommet at 1, and pull the harness
from the seat pan.
13. Remove the seat pan latch rod, 2; remove the
retaining hardware, 3.
90-5
Copyright © New Holland
8
9
10