New Holland LS140 Workshop Manual page 336

Hide thumbs Also See for LS140:

Table of Contents

Op. 35 730 18

1. Thoroughly clean the outside of the cylinder.

2. Pull the piston rod out slowly, and drain the oil

from the barrel into a suitable container.

3. Clamp the base of the cylinder in a vise at 1, and

unscrew the cylinder head (gland), 2.

NOTE: Do not clamp the cylinder barrel in the vise to

unscrew the cylinder head. Flattening of the barrel

will cause damage to the piston and piston seals.

4. Remove the piston rod assembly, 1, from the bar-

5. Remove the piston retaining nut, 1, the piston, 2,

spacer, 3, and cylinder head (gland), 4, from the

piston rod, 5.

SECTION 35 - HYDRAULIC SYSTEM

Chapters

Table of Contents