Starter Reinstallation - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

Performance Test

After reassembly, a no-load test should be

Clamp the starter securely in a vise. Connect a heavy

wire (jumper cable) from a 12 volt battery positive

terminal, through a suitable ammeter, to the battery

cable post of the starter, 1. Connect a second cable

from the battery negative post to the starter case or

vise. Connect a jumper wire from the positive cable

to the spade terminal on the solenoid, 2.

The pinion gear should jump forward and the starter

turn smoothly. Current draw should not exceed 130

STARTER REINSTALLATION

1. Attach the starter to the bellhousing and tighten

the hardware, 1. When installing the starter into

the bellhousing, make sure it is properly seated

before installing and tightening the hardware.

2. Reconnect the wires to the proper terminals, 2,

on the starter solenoid and starter.

3. Reconnect the negative (–) battery cable.

4. Reinstall and close any shields removed.

SECTION 55 - ELECTRICAL SYSTEM

Table of Contents