New Holland LS140 Workshop Manual page 508

Hide thumbs Also See for LS140:

Table of Contents

SEAT AND SEAT BELT SWITCH WIRING

To EIC Board Pin

To Seat Belt switch

LTGN/R From Electronics 5A

Fuse (engine panel)

To Service/Run

Op. 55 201 15

SEAT SWITCH REMOVAL

1. Disconnect the negative (–) battery cable.

2. Slide the seat to the most rearward position.

Raise the seat and securely latch in the raised

latched position, 1.

Never work under a raised seat unless it is

securely latched in the raised position.

3. Remove the seat retaining hardware, 2.

4. Holding the seat in place, lower the seat pan and

seat and unplug the seat switch(es).

5. Remove the seat from the loader.

6. Disconnect the wire harness from the switch(es)

by releasing the latch away from the switch.

7. Remove the switch(es) from the seat pan. The

standard seat uses one switch, 1, and the deluxe

seat uses two switches, 2.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents