New Holland LS140 Workshop Manual page 626

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

Attachment Plate Over-Center Latch Pins Wear/

The loader attachment may become loose at the

mounting plate. Inspection of the over-center latch

pins part #9822358, shows the pin ends worn and

The over-center pins are NOT heat-treated. Thus, if

an attachment does not fit correctly and hammers

against the pins, the pins will wear and bend. New

pins and ones used with properly fitted attachments

should be straight, as shown at 2.

If worn pins are encountered, the pins must be re-

placed. Additionally, an inspection of all the custom-

er's attachments must be made to determine the im-

properly fitted attachment which is causing the pin

problem. Usually, an old attachment used on a pre-

vious loader can be worn and can be the problem.

Chapters

Table of Contents