Properly Support A Raised Machine; Properly Support Boom On Boom Lock Pins; Raising Boom Without Hydraulic Oil Flow - New Holland LS140 Repair Manual

PROPERLY SUPPORT A RAISED MACHINE

If servicing neutral adjustment, final drive adjustment
or repairs requiring the machine to be raised,
securely support the machine with adequate jack
stands or blocks as shown.
Support the machine at 1 to the front of the final drive
cases and to the rear at 2, making sure the supports
are on the flat area of the final drive cases.
PROPERLY SUPPORT BOOM ON BOOM
LOCK PINS
Before servicing the machine or any of its attached
equipment, be sure that the attachments are lowered
to the ground or the boom arms are supported by the
boom lock pins, 1.
If the boom is to be raised on the boom lock pins,
remove any attachment. Opening a hydraulic line
could cause a mounted attachment to dump over
unexpectedly.
RAISING BOOM WITHOUT HYDRAULIC OIL
FLOW
(Engine Or Hydraulic System Not Functioning)
1. Remove any attachment from the boom
mounting plate.
2. Block the rear of the skid steer under the rear of
the final drive cases, 1, as shown.
This will prevent the front wheels from raising
during boom lifting.
SECTION 00 - GENERAL INFORMATION
00-14
1
10995765
2
1
4
5
6