New Holland LS140 Workshop Manual page 623

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
PARTS INSPECTION
Mounting Plate Assembly
1. Inspect the plate for straightness; if the mounting
plate pods are not straight with each other it may
be difficult to hook up to attachments. Refer to
Section 8 for more details on the procedure for
checking the mounting plate. If the plate is not
within specifications, replace the assembly.
2. Excessive wear in pivot pin holes, can result in a
sloppy fit. Replace the bushings in the plate.
3. Excessive wear in the latch pin area can result in
loose attachments. If the pins do not slide freely,
remove pin and clean and lubricate.
Latch Handle/Spring Assemblies
1. Examine latch handle pivot hole, 1, for excessive
wear.
2. Examine spring for looseness or broken coils, 2.
Latch Pins
1. Examine pins, 3, for excessive wear and binding
in mounting plate.
2. Check the tapered area of the pin for wear or
breakage at 4.
Op. 82 100 57
Pivot Bushings Replacement
1. Use a suitable bushing driver and remove old
bushings.
2. Clean the bushing area to remove any dirt/trash
and burrs.
3. Using a bushing driver, install the new pivot bush-
ings from each end of hole, 1. Drive bushings
flush with the outer edge of the hub.
NOTE: There will be a space in the center between
the two bushings.
82-34
Copyright © New Holland
75
76