New Holland LS140 Workshop Manual page 174

11. Remove the two front support pins, 1; remove the
return spring retaining bolt, 2; and remove the
neutralizer plate, 3. The hydrostatic control lever
assemblies, 4, can be removed for more access.
NOTE: The neutralizer spring will be under a small
amount of tension when removing.
12. Remove the dampeners, 1, and control linkage,
2.
13. Remove the suction line, 3, from the gear pump
and cap to prevent loss of oil.
14. Remove the pressure line, 4, from the gear pump
and cap to prevent loss of oil.
15. Remove the case drain line, 5, from the suction
fitting on the bottom of the gear pump and cap.
16. Mark hose location and remove all high- pres-
sure lines, 6, from the hydrostatic pumps and
cap.
17. Remove the inspection plate, 1, from under the
center of the loader frame to access the front hy-
drostatic pump support.
18. Remove the hydrostatic pump support bolt from
the main frame and the pump support plate.
SECTION 29 - HYDROSTATIC TRANSMISSION
29-29
2
4
1
19992561
4
1
6
2
3
19992562
Copyright © New Holland
3
4
36
1
6
2
5
37
38