Crankshaft And Bearing Holder Assembly - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

CRANKSHAFT AND BEARING HOLDER

1. With the bearing holders installed on the

crankshaft (see "Crankshaft Bearing Holders")

insert the assembly into the block from the

flywheel end. Slide the nose of the crankshaft

into the front bushing in the front end of the

cylinder block.

2. Rotate the bearing holders to align the hole in the

block web with the threaded hole in the bearing

holder and insert hex head bolts. The bearing

holder in the rear of the block is located and

secured by two socket head bolts which fit into a

recess in the oil pan mounting surface.

Bearing holder tightening torque:

Hex head bolts -

49 - 54 N⋅m (36 - 40 ft. Ibs.)

Socket head bolts - 24 - 30 N⋅m (18 - 22 ft. Ibs.)

3. After installation, measure crankshaft end play

using a dial indicator.

Standard End Play

0.1 - 0.4 mm

(0.004" - 0.016")

SECTION 10 - ENGINE

Allowable Limit

Chapters

Table of Contents