New Holland LS140 Workshop Manual page 518

Hide thumbs Also See for LS140:

Table of Contents

ENGINE FUSE BLOCK REMOVAL

1. Disconnect the negative (–) battery cable.

2. Remove the fuse block retaining hardware.

NOTE: The standard fuse block, 1, is part of the main

harness and cannot be completely removed from the

main wire harness and replaced separately.

3. The optional equipment fuse block , 2, locks into

the standard fuse block. Insert a 1/4" blade

screwdriver at the center of the fuse block bases

and twist to release the lock. Slide the optional

block up past the fuses on the standard block to

4. Unplug the wires from the fuse block assembly.

ENGINE FUSE BLOCK INSTALLATION

1. Insert the lock tabs, 1, into slots, 2, and slide the

two blocks together to lock securely as shown.

NOTE: The optional equipment fuse block slides

down over the standard block guides and is

positioned toward the center of the panel.

2. Attach the wires to the proper side of the fuses as

shown in the "ENGINE FUSE PANEL WIRING"

figure above.

Standard fuse block

Optional equipment fuse block

3. Reinstall the block retaining hardware.

4. Reconnect the negative (–) battery cable.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents