New Holland LS140 Workshop Manual page 483

Hide thumbs Also See for LS140:

Table of Contents

All grounding locations should be checked for tight

hardware and absence of paint between parts for

good connecting, as follows:

1. Check the grounding strap from the engine to

main frame, 1.

2. Check the wiring harness from the EIC to the bell

3. Check the grounding strap from the cab ROPS

structure to main frame, 1.

On the grounding strap from the ROPS to the

main frame, be sure the strap is attached

between the ROPS and the main frame (yellow

lower frame). DO NOT attach the strap between

the cab interliner (cab side screen sections) and

the main frame, as the cab interliner on these

skid steers is rubber-mounted to the ROPS and,

therefore, insulated from the ROPS. However, a

second strap may be added between the cab

interliner and the main frame and should cause

no ill effect.

4. Check the wiring harness grounds to the bell

NOTE: When attaching multiple ground wires,

always place the heaviest ground wire (battery

ground cable) next to the ground surface (bell

housing). Stack the remaining ground wires

according to wire size, largest on the bottom and

smallest last. Two wires in a terminal are considered

to be larger than a single wire of the same size.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents