New Holland LS140 Workshop Manual page 507

Op. 55 418 30
SERVICE/RUN SWITCH REMOVAL
1. Disconnect the negative (–) battery cable.
2. Remove panel, 1; retaining hardware, 2; and
lower panel from the support. Removal of panel,
3, may be required for easier access.
3. Remove the wires from the switch terminals.
4. Push the switch retaining tabs in and remove the
switch from the panel.
SERVICE/RUN SWITCH INSTALLATION
1. Insert the switch, 1, into the panel and insure the
locking tabs, 2, secure the switch.
2. Reconnect the wires to the proper terminals as
shown in the "SERVICE/RUN SWITCH WIRING"
figure above.
3. Reinstall the panel to the support.
4. Reconnect the negative (–) battery cable.
SECTION 55 - ELECTRICAL SYSTEM
19997757
55-82
Copyright © New Holland
3
1
2
92
93