New Holland LS140 Workshop Manual page 509

SEAT SWITCH INSTALLATION
1. Install the switch(es) into the seat pan, making
sure the switch is seated into the hole in the seat
pan, 1.
IMPORTANT: If the switch is not seated properly
when the retaining hardware is tightened, the switch
flange will be broken.
2. Reconnect the wire harness to the switch(es)
and reinstall the seat retaining hardware. Make
sure the harness connector latches are
engaged.
3. Reconnect the negative (–) battery cable.
Op. 55 201 14
SEAT BELT BUCKLE AND SWITCH
ASSEMBLY REMOVAL
1. Disconnect the negative (–) battery cable.
2. Unplug the seat belt wire harness, 1.
3. Remove the clamp hardware and clamp, 2, and
save for reuse.
4. Remove the seat belt retaining hardware, 3.
SEAT BELT BUCKLE INSTALLATION
1. Reinstall the seat belt buckle retaining hardware.
Tighten the locknut to hold the belt in position that
will allow the belt assembly to move front or
rearward.
2. Reconnect the wire harness.
3. Reinstall clamp holding harness above seat
track.
4. Reconnect the negative (–) battery cable.
SECTION 55 - ELECTRICAL SYSTEM
55-84
Copyright © New Holland
97
98