New Holland LS140 Workshop Manual page 232

Hide thumbs Also See for LS140:

Table of Contents

1. Install a new hand grip on the top of the handle,

1, if grip is worn.

2. Attach the ball end, 2, and jam nut, 3, to the rod,

4. Fasten the ball end to the handle, 5, with the

capscrew, 6, flat washer and locknut. Position the

flat washer between the ball end and handle. Do

not tighten the jam nut at this time.

3. Attach the handle assembly to the handle sup-

port, 7, with the long bolt, 8, and locknut, 9.

4. Tighten the locknut to remove any movement be-

tween the handle assembly and support, but do

not overtighten. The support should be loose

enough to allow the handle to pivot without bind-

5. Slide the handle tube up through the slot, 1, in the

handle support base.

6. Slide the handle sideways over the stub shafts.

7. Install the bearings, 2, on the handle, install shim

washers, 3, to center the handle in the slot, 1.

Fasten each bearing with two 5/16" x 3/4" car-

riage bolts, lock washers, and nuts at 4.

8. Install shim washers, 5, to reduce side play on

the stub shafts. Retain the shims on the stubs

shaft with a roll pin, 6.

9. Slide the rubber boot, 7, down over the end of the

control handle, one side at a time, and secure

with the the hardware removed during disassem-

10. Attach the handle and rod assembly, 1, to the

control handle by first sliding the rod down

through the control handle tube, 2.

11. Attach the handle assembly to the handle tube

arms, 3, with the short carriage bolts, 4, lock

washers, 5, and nuts, 6. Tighten securely.

SECTION 29 - HYDROSTATIC TRANSMISSION

Chapters

Table of Contents