New Holland LS140 Workshop Manual page 538

Hide thumbs Also See for LS140:

Table of Contents

15. Remove all wire harness retaining clamps from

the main wire harness at the rear and left side of

the loader frame, 1.

(Cut wire ties along the right side of the rear

window if so equipped and any ties retaining the

optional harness to the main harness. Cut the

wire tie at the keeper bar at the left front to rear

of cab pivot).

16. Thoroughly clean the connector between the

main and engine harness, 1. Make sure the

connector is dry.

17. Unplug the main wire harness from the engine

wire harness, 1, and remove the ground wires

from the engine bellhousing ground stud, 2.

Remove wires from the engine fuse and relay

18. Remove the hydraulic oil temperature sender

wires, 4, and remove the harness from the

clamps on the bellhousing at 5. Remove the

remaining bellhousing clamps.

19. Remove harness, 1, from the left rear of the

engine area after disconnecting wires from the

fuel sender, 2; fuel pump, 3; and air cleaner, 4.

SECTION 55 - ELECTRICAL SYSTEM

Chapters

Table of Contents