New Holland LS140 Workshop Manual page 612

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

4. Remove the hoses from the rear hose support, 1,

remove the tube clamps, 2, and disconnect the

tubes at the Z-bracket and quick couplers at 3.

5. Remove the right and left upper boom cylinder

pivot pin retaining hardware, 1, and pin, 2, from

cylinders and boom.

NOTE: If only the main boom is being removed, the

cylinders can remain attached at the bottom pivot.

6. Loosen the right and left lower link rear pivot pin

retaining hardware, 1.

Do not remove the pin retaining hardware until

the tapered pivot pin is broken loose at the ta-

pered end of the pin, or the link and pin may fall.

7. With a soft-faced sledge hammer, strike the low-

er link at 2 to brake the tapered pivot pin loose in

the main boom link.

Chapters

Table of Contents